 Most viewed - Wings |
First test steam. Rags are in the ends of the tube to help contain the steam, but allow some venting366 views
|
|
Cutting the notch on the router.366 views
|
|
... and cutting the other end on the band saw.365 views
|
|
Hmmm... methinks it needs more support.364 views
|
|
Preparing to drill pilot hole in block. Note reference mark for alignment in jig 360 views
|
|
Lifting the cap strip...358 views
|
|
I precut all the vertical cap strip pieces previously, but the angles I did as needed by hand.357 views
|
|
After steaming, the capstrip is clamped in a form.355 views
|
|
I used the nose piece as a template to mark the curve that goes on the end of the cap strip.355 views
|
|
Getting ready to use the rib as a template to male the master nose rib.355 views
|
|
Test piece - 1st piece cut from the template353 views
|
|
As you can see it didn't take much to make the curve.353 views
|
|
| 184 files on 16 page(s) |
 |
|
|
|
|
9 | |
|
|
|
|
