 Most viewed - Wings |
... while at the same time rotating it up to make the curve.336 views
|
|
Cutting one end on the band saw...336 views
|
|
My jig for cutting the notch is a scrap piece of wood I ripped on the table saw with the fence set for 1/16.335 views
|
|
Squaring off the 1/16 notch with the file.335 views
|
|
Nose Piece "Master"333 views
|
|
Put a small tack to hold the pieces together after the first bend333 views
|
|
Formed flying & roll wire lugs332 views
|
|
Gluing the aileron rib331 views
|
|
Gluing side 2 of an aileron rib 331 views
|
|
I used a piece of 100 grit sand paper to shape the end. Ten or twelve passes was all it took.331 views
|
|
Rough cut scraps and the Nose Piece "Master"330 views
|
|
Close up of the clamps. Note the acrylic squares used to spread out the clamping force and also keep the clamps from getting stuck to the rib 330 views
|
|
| 184 files on 16 page(s) |
 |
|
|
|
|
7 | |
|
|
|
|
