 Most viewed - Wings |
There was often glue residue to be cleaned up afterwards.399 views
|
|
Screwing down block pieces 397 views
|
|
Trimming excess gusset material on the router397 views
|
|
When it came time to remove the rib from the jig I would "pinch" the cap strip and lift it to break the glue bond with the jig.397 views
|
|
First pass on the band saw.395 views
|
|
Threaded Rod Ends395 views
|
|
Two ribs in process. One in the jig (on the chair) and the other having "side 2" glued (on the bench)394 views
|
|
Threaded Rod Ends394 views
|
|
The router bit obviously leaves a curve at the end of the cut. This needs to be squared off.393 views
|
|
Nose Piece "Master"388 views
|
|
I used a piece of 100 grit sand paper to shape the end. Ten or twelve passes was all it took.388 views
|
|
... while at the same time rotating it up to make the curve.388 views
|
|
| 184 files on 16 page(s) |
 |
|
|
|
6 | |
|
|
|
|
|
