 Last additions - Wings |
I lined up the piece over its location... 325 viewsDec 22, 2010
|
|
I precut all the vertical cap strip pieces previously, but the angles I did as needed by hand.356 viewsDec 22, 2010
|
|
Top cap strip finished.328 viewsDec 22, 2010
|
|
Bottom cap strip finished.335 viewsDec 22, 2010
|
|
Squaring off the 1/16 notch with the file.379 viewsDec 22, 2010
|
|
A triangular hand file does the job nice in just a few passes.337 viewsDec 22, 2010
|
|
The router bit obviously leaves a curve at the end of the cut. This needs to be squared off.393 viewsDec 22, 2010
|
|
Cutting the notch on the router.373 viewsDec 22, 2010
|
|
Cutting the notch on the router.366 viewsDec 22, 2010
|
|
Top & bottom cap strip marked for 1/16 notch.330 viewsDec 22, 2010
|
|
Same thing for the bottom.310 viewsDec 22, 2010
|
|
Next I marked the location where the 1/16 notch should end.462 viewsDec 22, 2010
|
|
| 184 files on 16 page(s) |
 |
|
|
|
|
7 | |
|
|
|
|
